Fmi Q647 User Manual download pdf

The FMI Mounting Base Kit Q647 allows horizontal or vertical mounting of "Q" line pumps. It replaces the

Multi-Position Tilt Stand Q650 that is standard on most models.

1.0 Read Safety Instructions carefully before attempting to install Q647 Mounting Base Kit.

2.0 Remove Q650 Multi-Position Tilt Stand from base assembly by loosening the two mounting screws

washers, weld nuts, cross bar and protective caps.

3.0 Remove the two rubber feet and drive screws from base assembly.

4.0 Reverse the stroke adjustment assembly *Remove speed knob from the assembly (Not required),

and add Q447 Flow Control Bushing (Refer to Fig 1 ).

5.0 Install Mounting Base Q648 by positioning the Mounting Base under the assembly and lining up the

mounting holes. Secure using self tapping screws 110528-6 in the front and Socket Head Screws

110290-12, Lock Washers 110049 and Hex Nuts 110133 in rear (Refer to Fig 1).

6.0 See Figure 2 for Mounting Base Q647 Bolt Hole Pattern.

Q647 MOUNTING BASE KIT

(PLEASE REFER TO DRAWINGS ON REVERSE SIDE OF THIS SHEET)

Assembly Instructions Q647 Mounting Base Kit

Fig 1

QTY

PART NO.

PARTS LIST

DESCRIPTION

ITEM

110049

WASHER, INT. TOOTH LOCK #8

110133

NUT, HEX 8-32 X 11/32"

110290-12

SCREW, SHC 8-32 X 3/4"

110528-6

SCREW, PHS 8-32 X 3/8" SELF TAP

Q447

FLOW CONRTOL BUSHING

Q648

PEDESTAL BRACKET, QP

CERAMPUMP

www.fmipump.com

(2X)

1/4-20 LOCK NUT

1/4" FLAT WASHER

FOLLOWER

KNOB ASSEMBLY

FLOW CONTROL

BUSHINGS

HEX NUT

(SNUG UP)

Fig 2

IN-Q647 / 09

Q647 MOUNTING BASE KIT 1

Summary of Contents

Page 1 - Q647 MOUNTING BASE KIT

The FMI Mounting Base Kit Q647 allows horizontal or vertical mounting of "Q" line pumps. It replaces the Multi-Position Tilt Stand Q650 that

Comments to this Manuals

No comments

Fmi Q647 User Manual

Browse online or download User Manual for Hardware Fmi Q647. FMI Q647 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Fmi Q647