Page 1 of 18 PDS-100 Programmable Dispensing System INSTRUCTION MANUAL OVERVIEW The PDS-100 is a precision system capable of dispen
Page 10 of 18 Main Screen (Pump A in continuous mode & Pump B in Dispense mode): Speed adjust from external source Press the up/down ar
Page 11 of 18 Analog Input Connector and Specifications The PDS-100 incorporates a simple screwless (spring loaded) terminal strip (see figure 6) for
Page 12 of 18 Analog Input Connector and Specifications (cont’d) Figure 7 Input Resistance Schematic (Analog input: 0 – 5 VDC or 0 – 10 VDC)
Page 13 of 18 RS485 Connector Pin, command set and specifications Figure 8 RS485 Control (Rear Panel) Figure 9 RS485 Control (Rear Panel) Pin On
Page 14 of 18 RS485 Connector Pin, command set and specifications (cont’d) Note: PDS-100 accommodates up to 31 addressable units. Command Mapping
Page 15 of 18 Configuration Modes Screens (Appears when Up Arrow and setup Keys are held down while powering up unit) The unit comes pre-con
Page 16 of 18 Table 4 Pump Operating Parameters Waveform Graphs 1 - 9 Waveform #1 Waveform #2 IN-PDS100-13A 11/1/13 HW
Page 17 of 18 Waveform #3 Waveform #4 Waveform #5 Waveform #6 IN-PDS100-13A 11/1/13 HW
Page 18 of 18 Waveform #7 Waveform #8 Waveform #9 IN-PDS100-13A 11/1/13 HW
Page 2 of 18 Smooth Flow Operation The PDS Smooth Flow product differs from the “Standard” PDS-100 in that the dual pumps have each been precis
Page 3 of 18 Power Up Screens (two individually controlled pumps) This is what will be seen on power up when the unit is configured for individuall
Page 4 of 18 Setup Screens (two individually controlled pumps) Prime/Purge, Mode & Input Setup Screens To select “Prime/Purge, Mode & Input
Page 5 of 18 Setup Screens (two individually controlled pumps) cont’d: Prime/Purge adjust and activation Prime and Purge have the following available
Page 6 of 18 Setup Screens (two individually controlled pumps) cont’d: Mode and direction adjust Mode has the following available settings for direct
Page 7 of 18 Setup Screens (two individually controlled pumps) cont’d: Control and start method Input has the following available settings for Inpu
Page 8 of 18 Setup Screens (two individually controlled pumps) cont’d RS485 setup RS485 has the following available settings for Interface & Dev
Page 9 of 18 Main Screen (both pumps in dispense mode): Speed/Strokes adjust via keypad Press the up/down arrow keys then the enter
Comments to this Manuals